lighting ideas and suggestions for the home

Bathroom

Bedroom

Dining Room

Kids Room

Kitchen

Lightbulb Types

Living Room

Study

Bathroom lighting needs to be bright and fresh giving good visibility through a variety of techniques. Ideally the scheme should be flexible ensuring a bright and invigorating light by morning to a softer more subdued ambience for evening.This can be achieved by installing a dimmer switch ensuring adaptability to changing needs.


Great care needs to be taken when choosing bathroom lighting as the regulations are strict concerning the type of light you can use.  

Mirror

The bathroom mirror deserves some special attention and a diffused glass light either side will give a good general illumination where it is needed. The alternative is a halogen downlight from the ceiling or fluorescent strip light over the mirror.


The latest generation of mirrors incorporate lights into the mirrors themselves with sections of the reflective surface removed and lights fitted behind them. This is a very effective way of generating an even light and improving safety.

General

For general illumination in the rest of the bathroom either use downlights for their refreshing halogen colour or a high output flush ceiling fitting to suit the dècor.


Portable lights are not permitted in a bathroom so for mood lighting use ceiling mounted directional spotlights aimed away from the bath and at interesting features.


Lights designed specifically for showers are available and must be carefully fitted according to the instructions.

Bathroom Lighting Safety

The following information is a guide to help you understand what fittings can be placed where. This is not an installation guide and reference should be made to the IEE Wirings Regulations (16th Edition) or a qualified electrician.


Firstly it is important to understand the rating by which bathroom and some outdoor lights are classified. IP rating stands for ‘Ingress Protection’ and is always followed by two characters. These two numbers refer to level of protection and it is important that you choose fittings with the correct rating according to where they are to be sited within the bathroom.

Zones

The diagram on the right shows a bathroom split into four clear zones: 0, 1, 2 and 3.


Zone 0 is inside the bath or shower itself. Any fitting used in this zone must be low voltage, (max 12v) and be rated at least IP67 which is total immersion proof.


Zone 1 is the area above the bath to a height of 2.25m from the floor. In this zone a minimum rating of IP44 is required. If the fitting is 240v a 30ma residual current device (RCD) must also be used to protect the circuit in this zone.


Zone 2 is an area stretching 0.6m outside the perimeter of the bath and to a height of 2.25m from the floor. In this zone an IP rating of at least IP44 is required. In addition it is good practice to consider the area around a wash basin, within a 60cm radius of any tap to be considered as zone 2.


Zone 3 is anywhere outside zones 0,1 and 2 (subject to specific limits) and where no water jet is likely to be used. No IP rating is required.


In addition to the above, if there is a likelihood of water jets being used for cleaning purpose in zones 1,2 and 3 a fitting rated a minimum IP65 must be used. Full details can be found in the latest copy of the IEE wiring regulations.